Bristol-Blue Lake Michigan Sailing Adventures

Last trip out The season ender this weekend was delayed by one day.  We had planned to sail our last day of the season Saturday with some friends however the wind was blowing 20-25 knots.  With 2 little kids we thought it would be a bit much to take new sailing friends out on the lake.   All ended well though we made it out Sunday afternoon for one final round on the lake. Photo of boom reef  The wind was still blowing a pretty gusty 12-15 knots today so we stared with a reef in the main.  We are just out to relax.  I have on my  sailrite  main right now and it has reef points built in.  However I have not run the lines so I just roller reefed it in with the boom.  I really think the roller reefing is one of the most convenient features on this boat.  It is a bit of a pain to have to pull the topping lift off to turn the boom but really not that big of a deal.  Next season I'm going will splice in an extra clip to the topping lift line.  This clip will be used on

Around a year ago I published a post about sailing alone with a three year old.  Today I thought hey he's a whole year older.  Sailing alone with a four year old is different than a three year old.  Sure three and four year old's both want to help and be engaged.    However the four year old is far more capable of "helping out" on the Typhoon.  This can be good, it can also be bad. Four year old's remember stuff.  They know where you put those sail ties and can retrieve them for you. Four year old's remember stuff and will tell on you . Four year old's are stronger so when it comes to light wind days they can actually trim the jib.  "Maybe next year we will learn to tie off cleats." Four year old's are stronger so they can break things more readily. Four year old's can help rinse the deck with a hose when you are cleaning. Four year old's have their own ideas about how clean the boat should be, and may fill yo

I bit the bullet here and decided it was time to suck it in and climb my way to the back of the Typhoon.  This has been some time in the planning but just hasn't happened until today.  I've been using my Genoa blocks for my Spinnakers for sometime now. With the new full mast length spinnaker the time has come to set up some proper blocks at the stern of the boat.   Into the black abyss Sky light. Thru bolts In the following picture you can see the difference this will make.  When I'm heading up I can get a lot more out of the kite turning 10-12 degrees higher. Genoa, Spinnaker blocks  For my final set up I plundered the blocks and stand up springs off my ice boat. The mount is through the taft rail one bolt and the rear is actually a screw.  I was a bit worried a bolt on the aft might puncture the hull.  I can tie off the sheet lines at the rear dock cleats or run my line backup into the cockpit. Final set up 

It's been a while since I've posted.  Oh well, I've been busy sailing.  I finally stopped long enough to do the maintenance coat on the varnish.  My wife got home from work and I made a B-line for the door.  I spent a warm warm summer evening scuffing and coating the varnish.  I thought I'd done a pretty decent job with the exception of one location where I knew I had a run but couldn't get it to work out.  I figured I'd scuff it out in a few days and touch up the area. Cape Dory Typhoon at sun set. Now the problem.  I ended up with a heavy dew setting in that night.  The result was a a glazed effect on all of the teak I'd done the night before.   Glazed teak from early dew. I was less than thrilled.  After a couple of days of grousing about it, I headed down again.  This time on a warm/hot morning.  I ended up scuffing up all the teak with some 220 sand paper and then going over it again with a fine 3M scuff pad.  It was at this point I was thi

Masthead Spinnaker Fitting on " Kraken ".  Cape Dory Typhoon.  Cape Dory Typhoon Spinnaker Fitting. Cape Dory Typhoon Cape Dory Typhoon Spinnaker Set up.

So this season I have been gearing up and changing my rigging around bit by bit as I find pieces here and there.  My ultimate goal is to  rig up a mast top spinnaker for use later in the season.  So far, I've got the mast head halyard set up.  Today I took the next step and installed a removable compression post.  My Typhoon has the saddle supports that came with older Cape Dorys but I thought it best to add a bit of extra support before trying out the mast head spinnaker. So here is what you will need:  A nice piece of teak, two other (less nice) hardwood boards for underneath the floor cut to 4 1/2 inches,  epoxy, 3M permanent mounting tape and a master lock adjustable door jam.. I routered the teak to give it a soft edge for when I bang my head into it.   Nice board ready to install. Setting the Teak upper. I drilled holes in the back of the teak plate to match the mast step through bolts.  I did not remove the mast step and put extended bolts on.  I wanted a smoot

Just out for a sail on a nice clear day.  Lake Kalamzoo was fun as usual.  A little lunch and a bit of sailing.  We even pulled out the small spinnaker and played with it for a bit.  Check out the pictures below. Cloud Through the Spinnaker. J A wrinkle in TY. Look at that. Mom said smile.  The Headless helms woman.